CARE AND USE INSTRUCTIONS FOR CARLSBAD HAT LEATHER GLOVES
Like all leather products, leather gloves need careful care to last a long time. Please pay attention to the information below, as a product that has been handled carelessly will not be accepted for a warranty claim.
Putting on gloves – carefully slide your fingers into the glove and, interlacing the fingers of your other hand, help push the glove all the way down. Don't pull hard on the edge of the glove, or it will lose its shape. When choosing the right size, the glove you try on must be very tight on the hand. The leather we use is very fine and stretchy and adapts to your hand very quickly.
Taking off gloves – carefully pull them off, ideally by turning them inside out. Never pull a glove off by the fingers with force. A gentle tug at the fingertips can loosen it from your hand.
Some manufacturers recommend spraying gloves with leather products sold in shoe shops. We strongly advise against this!! They contain large amounts of silicones that can irreversibly damage the leather. Bear in mind that leather darkens and stiffens slightly when wet. With further wear the leather softens again.
If your gloves get wet, let them dry naturally and do not use any other source of heat (a hair dryer, a radiator or even the sun).
For light soiling, use a colourless cotton cloth, dampen it and wipe off the dirt. Ideally do this while wearing the gloves. You should not soak the gloves. Carefully take them off, smooth them on a flat surface and let them dry on a colourless cotton cloth, again naturally, not in the sun or on a radiator.
Once dry, you can straighten or "stretch" the gloves with a gentle pulling movement over a blunt table edge. Then put them on and smooth them further to the shape of your hand.
For heavier soiling, a professional cleaning service is necessary.